The FlyTroniX Radiance LEDs are a range of LEDs designed from the ground up for a variety of use cases. This kit is specifically designed for the TinyTrainer v1 and v2 frames by Five33.

These LEDs are fully addressable via a Flight Controller. Each LED has the ability to be individually controlled in terms of colour and brightness, all via a single set of 3 wires! They can be configured in two different ways, as follows:

Soldering the SERIES jumpers (Default), will cause the LEDs on the center board to act as number 1 through 4 in the string, with the LEDs on each arm acting as numbers 5 through 8 in the string.

Soldering the PARALLEL jumpers will cause all four LEDs on the center board to act as number 1 in the string, and the LEDs on each arm board will then be numbers 2 through 5.

Specifications:

– Current Draw: 650mA maximum.

– Input voltage: 5V ONLY.

– Arm Board Size: 7.5mm * 28mm

– Center Board Size: 14mm * 44mm (Fits exactly on top 25.5mm * 25.5mm Flight Controller)

– Colours: 16.5Million possible colours, customizable through Flight Controller.