PDB

Lumenier 4Power + Plus PDB
Lumenier 4Power + Plus PDB
The Lumenier 4Power + Plus PDB is a feature-rich power distribution board designed for small quadcopters. The board uses the standard 30.5mm mounting hole pattern (common to most flight controllers) to easily fit up to most airframes.
Features:
Input voltage range (3S-6S operation): 8 – 26VDC
PDB: 4x30A (Max.4x46A)
Regulated 5V (1.5A) and 10V (1.5A) outputs
Current Sensor 184A
Specifications:
2oz copper, 4-layers &1.6mm PCB.
1x Battery input, 4x ESC outputs. 2x BEC 5V outputs, 2x BEC 10V outputs.
Current Sensor, Gnd pads, Video Transmitter Signal & Gnd pads
Dimensions: 46x36x4mm, Weight: 8.5g
Mounting holes 30.5mm square spacing,Φ3mm
PDB (ESC outputs):
Continuous current: 30A per output Peak current (10 seconds/minute): 46A Max per output
BEC 5V outputs:
Designed for RC Receivers, Flight controllers, OSD, and Servos.
DC/DC synchronous buck regulator.
Voltage: 5.0 +/- 0.1VDC
Continuous current: 1.5 Amps (Max.2A 10s/minute)
Output Ripple: 40mV (VIn=16V, VOut=5V@2A load)
Short-circuit tolerant (5 seconds/minute)
BEC 10V outputs:
Linear regulator, very low noise. LC Filter is needless.
Designed for Video TX or FPV camera.
Stable power output even on low voltage 3s (below 12v)
Voltage: 10.0V +/- 0.3VDC (4~5S operation)
Continuous current: 1.5A@16V IN (2A Max)
Short-circuit tolerant (2 seconds/minute)
Current Sensor:
184A / 3300mV
Includes:
1x Lumenier 4Power + Plus PDB
1x Lay-Flat XT60 power connector
1x Set of Nylon standoffs
4x M3 6mm hex standoff
4x M3x12mm screws
4x M3 hex nuts